Below you can see example of ECUsafe reaction to opening EEPROM file (notice that proper file type must be done.) This example is with Audi 3.0 TDI EDC16 EEPROM: EEPROM checksum is calculated automatically. Point of FAP level storage will be detected automatically.

Remember to choose proper brand of car and ECU type. Read EEPROM and open binary file in ECUsafe. This value is stored in EEPROM and must be cleared (set below threshold). In cases, when even after removing FAP/DPF there is blinking lamp at dashboard, this means, that level of FAP at moment of removal was over critical point (vary from car manufacturer to car manufacturer). Otherwise it is red.ĮCUsafe can automatically process EEPROM files (read in programmer or extracted with BDM tool). After finishing scanning it is green checked if file is patched successfully. If it is pale yellow – data is found and scan goes slower. When square indicator on the right of progress bar is gray checked – empty or unimportant area is found and scan goes faster. – after finishing of scan – information about success or failure of scan will be shown. – structures, that are found (here in this example: PPD1.1 L1 structure in DTC table (responsible for Particle Filter pressure sensor) While processing file comments will be visible: If it finds new databases, it shows popup window with information about newer databases.

It tries to get newer databases (if available). “Check for updates” button invokes updater for databases. This invokes web form, where user should give his e-mail and description. If file is unsuccessfully scanned and you want it to be manually processed by us, and it’s structures to be added to ECUsafe database, press “Upload file”.

“Cancel scan” can stop scanning at any time.īy pressing “Online Help” button, this manual will be invoked in your browser. Pressing it will open dialog, where file can be named and saved. Strategy Maps should be switched on anyway.Īfter finishing processing of file, “Save binary” button will be enabled. In case of diagnosis problems, switch off “DTC Error Tables”. In case of too high NOx levels, switch off “Postinjection” removal. In case of strange behavior (no power at all) try switching off “Torque limiters”. When button is red, that patch type wont be applied. In case of troubles you can switch off (by clicking appropriate button) some types of patches, that may be applied by ECUsafe to your binary. Progress will be visible on progress gauge. This may take quite a long time, especially when “Use 2nd pass” checkbox is checked. Use 2nd pass – use additional heuristic pass trough data if first pass was unsuccessful.Ĥ.Select binary to be processed – Open binary buttonĪfter opening binary (“Open binary”)ECUsafe starts to process it. Remove DPF – select to scan for DPF / FAP structures and switch them off.įind speed limit – select to scan for speed limit structures and change them. Protection – select to scan for locking OBD read of file.

Fap dpf off software download